Nautel NV30LT-N, Руководство по эксплуатации и техническому обслуживанию

Страница: 110 / 226

NV30LT-N OPERATIONS & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
PAGE 3.2.92 VERSION 0.1 2015-03-01
Figure 3.2.77: Network Settings screens
Displays a number that serves as unique network adapter
identifier. This is set by the manufacturer and is displayed for
informational purposes only (cannot be user set). It may be
necessary to use this number to allow the AUI to access your
network.
Set to ON to automatically assign the IP Address, Netmask,
Gateway, Nameserver 1 and Nameserver 2 by the access point
(i.e., a router) or set to OFF to manually assign. In either case,
the access point must be configured with the correct settings,
which match the settings on the AUI in order for the AUI to
access the network.
All addresses shown are for
reference purposes only
Address that identifies the DNS host. The DNS (Domain Name
System) translates internet domain and host names to IP
addresses. DNS automatically converts the name typed into a
web browser address bar to the IP addresses of web servers
hosting those sites. If DHCP is set to OFF, specify the address.
Masks an IP address, and divides the IP address into network
address and host address. If DHCP was set to OFF, specify
netmask. Typical netmask address shown. Consult with your
network administrator.
Used to identify the senders and receivers of messages. Also
supports port forwarding (remapping) which allows the AUI of
multiple transmitters to be accessed on the same network. See
your network router documentation for additional remapping
information and instructions. NOTE: Changes to this port are
reset to 3501 after a software upgrade; reconfigure the port, as
required, after an upgrade.
NTP = Network Time Protocol.
Set to
ON to allow the transmitter to synchronize to the network
time.
Set to
OFF to use the transmitter’s internal time reference.
Displays a unique numerical network identifier for the
transmitter. If DHCP was set to OFF, specify the IP address.
Consult with your network administrator.
Displays the address of the network access point. If DHCP was
set to OFF, specify the gateway address. Consult with your
network administrator.