NARDA PMM 7010 Series, Руководство пользователя

Страница: 19 / 76

Installation 2-3
2.10 Hardware
Installation PMM 7010 is delivered from factory ready to use. Remove the receiver from
its cardboard shipping box, connect properly the universal power supply and
switch ON the Power button.
In this way the LINE Led lights up to indicate the receiver is correctly
powered.
To avoid unwanted starts and stops, the Power button is placed in an
adequate recess.
After having been switched ON, the PMM 7010 boots with its internal BIOS
and runs the firmware which manages the receiver.
At the beginning the instrument performs a diagnostic test to check if
everything is working properly.
The boot sequence is very fast and the receiver is ready to use in a few
seconds after having switched the ON button.
When the initial sequence is completed the receiver is ready to be controlled
by the PC, running the PMM Emission Suite software.
The main screen shows the last sweep.
Connect the output of any LISN, or antenna, or absorbing clamp or any other
transducers to the RF input, ore use the internal LISN for conducted
emissions test.
When using a PMM LISN, it is possible to control from the receiver the lines
of the LISN and automatically switch between them connecting a special
cable between the User Port of the receiver and the LISN remote control
input.
Press the button to the “0” position to switch the apparatus OFF.
Fig. 2-1
PMM Emission Suite and 7010 initial screen showing the last
sweep.