NAPCO GEM-DXK1, Инструкция по программированию

Страница: 40 / 60

LIBRA LIB-P432EX Series Programming Instructions NAPCO Security Systems
Page 40
ACCESSING USER PROGRAM MODE
1. Press EEEEEE
w
2. Press PRIOR ("
X
" or
q
) until "
ACTIVATE PROGRAM Y/N
" appears on LCD screen.
3. Press YES ("
r
" or
p
) to enter User Program Mode.
4. Press RESET (
y
) to exit User Program Mode when finished.
New Panel (Default User Code = 123)
Existing Panel (Any Code with User Program Option Enabled)
USER CODES
Up to 64 User Codes may be programmed.
NOTE: In this mode, only the code is pro-
grammable; the accompanying Area Options
must be programmed in the Dealer Program
Mode (see page 5).
Use the
w
button to place the cursor
over the User Number.
Enter a User Number (01–8) using the
number buttons. The cursor will then
advance to the User Code and read the
existing code, if any.
Enter the new User Code using the number buttons (0-9). If an old code is displayed, program over it. To erase the digit at the
cursor, press
G0
button.
Press the
u
button to save the code in memory.
Repeat this procedure for each user. To proceed to Zone-Description programming, press the NEXT ("
r
" or
p
) button or
the PRIOR ("X" or
q
) button.
GEM-DXK1 Keypad (Direct Entry)
Enter user code
U01 123 - 9-
E n t e r u s e r c o d e
U 0 1 1 2 3 - -
Programming User Codes with GEM-DXK1 Keypad
To Program User Codes
1. Set Cursor Position using the
w
button.
2. Enter 2-digit User Number (01-
64) directly using number but-
tons (0-9).
3. Enter Code (1-6 digits) directly
using number buttons (0-9).
4. Press the
u
button to save
each code.
NOTE: Press
G 0
button to clear character at cursor.
To continue press
p
or
q
button.
User Code
NOT USED