NAPCO GEM-DXK1, Инструкция по программированию

Страница: 23 / 60

NAPCO Security Systems LIBRA LIB-P432EX Series Programming Instructions
Page 23
ZONE ANDING TIME WINDOW (ADDRESS 2061)
Zone ANDing Time Window :
With Zone ANDing enabled, the system will go into alarm only
if any two zones in a group are tripped within a specified period of time. With this address, this time
window is adjustable between 1 and 255 seconds. The factory default is 60 seconds.
Note: If
the address is programmed to 0, the panel defaults to 60 seconds.
1. Enter digit only.
2. Valid entries are: 001-255. NOTE: Default is 60 seconds. Press
u
to save.
ADDRESS 2061
[Default = 060 ]
Zone
ANDing Time
Window
(seconds)
KEYPAD UNBLANKING TIME WINDOW (ADDRESS 2060)
Keypad Unblanking Time Window :
If a keypad is Blanked / System event mode, ena-
bling the keypad to Normal requires a Set / Unset code + Enter (level 2/3/4) to come alive.
The keypad will stay alive (Normal) for 128 seconds (default) or for a time in a programma-
ble EEProm location in seconds. This location, 2060, contains a 3 digit decimal. During
exit/entry delay all keypads will always come ALIVE (Normal).
1. Enter digit only.
2. Valid entries are: 001-255. NOTE: Default is 60 seconds. Press
u
to save.
ADDRESS 2060
[Default = 128 ]
Keypad Un-
blanking Time
Window
(seconds)
CLOCK ADJUSTMENTS (ADDRESS 2281)
2281
Default
Option
OFF
1 Enable Daylight Saving Time
OFF
2 Clock Source (Internal Panel )*
OFF
3 Line Frequency--Enable 50Hz **
OFF
4 RESERVED
OFF
5
RESERVED
OFF
6
RESERVED
OFF
7
RESERVED
OFF 8 RESERVED
Clock Adjustments
Clock Adjustments:
1. Select the desired option entering the
option number (1-8) for each digit.
2. Enter corresponding option number in
address location.
NOTE: Dark shaded rows indicate option not avail-
able.
3. Press
u
to save.
*[Default = AC Source used]
**[Default = 60Hz]