N&W Global Vending Diesis 500, Установка, эксплуатация и обслуживание

Страница: 19 / 60

© by N&W GLOBAL VENDING S.p.A.
13
11 2008 3275 00
PAYmENT SYSTEm ASSEmBLY
The machine is sold without any payment system.
As a consequence, only the installer will be liable
for any damage that may be caused to the machine
or to things and persons by an incorrect installation
of the payment system.
Mount the coin mechanism by paying attention to the fol-
lowing, according to the type of coin mechanism in use:
choose the most suitable fastening holes; -
loosen the fastening screw and adjust the coin insert
-
slide according to the coin mechanism entrance;
loosen the fastening screws and adjust the lever in-
-
tended to open the selector:
to facilitate assembly, lift and turn the plate intended to
-
support the coin mechanism.
ELECTriC CONNECTiON
the machine is arranged for electrical operation at a
230 V~ single-phase voltage and it is protected by 15 a
fuses.
For connection make sure that the rating will comply with
the mains data, in particular:
the supply voltage value shall lie within the limits rec-
-
ommended for the connection points;
the main switch shall be featured in such a way that it
-
can support the maximum load required and to ensure
omnipolar disconnection from the mains with an open-
ing gap of the contacts of min. 3 mm.
The switch, the power socket and the correspond -
ing plug shall be located in an accessible position.
the electrical safety of the machine is only ensured
when the machine is correctly and efficiently grounded
according to the safety standards in force.
It is necessary to check this fundamental safety require-
ment and, in case of doubt, to require professionally
qualified personnel to check the installation carefully.
The supply cable is of the type with a fixed plug.
If necessary, the connection cable shall be replaced
by qualified personnel by using only cables of the HO5
rn - F or Ho5 V V-F or H07 rn-F type, 3x1-1.5 mm2 in
cross-section.
It is forbidden to use adapters, multiple sockets
and/or extensions.
THE mANuFACTurEr WiLL DiSCLAim ALL rE-
SPONSiBiLiTY FOr ANY DAmAgE CAuSED BY THE
NON-OBSErVANCE OF THE PrECAuTiONS mEN-
TiONED ABOVE.
Fig. 17
Lift cover 1-
Cable clamp 2-
Mains cable 3-
Fig. 16
Selector opening lever 1-
Coin slide 2-
Slots for plastic inserts 3-