NAC Image Technology SP-642, Руководство пользователя

Страница: 389 / 436

(00292)H 14 - 5
■Camera unable to VIEW
With a multi camera head DRP such as the RX-5, if camera heads not connected to DRP have HXLink
camera connections, the following message is displayed during VIEW.
If the aforementioned is displayed, camera heads are not connected to the MEMRECAM fx RX-5 PM
Unit port 2 so VIEW is not possible. End camera control one time with HXLink and either connect the
camera head to port 2 or connect the camera with the port 2 configuration.
If using GX cameras, VIEW may not be possible when a video warning is displayed.
If a video warning is displayed, confirm that the camera is not in use (in particular, not saving on the
USB) and if not in use, click “Stop” to delete the warning shown on the video. Since there are
multiple warnings displayed, click “Stop” until the warnings are no longer displayed.
■The video display or the PC live image does not work on the GX camera during VIEW/ARM or
there is noise
If the camera sync setting is “EST”, the image is not updated during VIEW if there are no EST
signals.
If not using EST, set “Sync HX, GX Camera” to “Internal Sync” in the “Options” dialogue or
under the “Sync Settings” tab in the “Camera Connections Settings” dialogue.
If using EST, check the following.
・
Are the EST signals properly input into the connector specified in “Input/Output Settings” in
the options dialogue?
・
Is the shutter speed for the recording parameters (frame rate if OPEN) set slower than the
EST signal frequency?
■ The recording date for the HX, GX camera is January 1 or December 31
Under the “Sync Settings” tab of the “Options” dialogue or the “Camera Connections Settings”
dialogue, if the “HX, GX Camera Time” setting is “IRIG
・
M-HUB Time”, any of the following
may be generated.
・
The IRIG signals are not connected to the GX-HUB.
・
With combined HX, GX, fx use (using the M-Hub), the HXLink does not control the “fx
Camera for M-HUB Control”.