Mylex FlashPoint BT-930, Руководство по установке и инструкция пользователя

Страница: 56 / 70

Q&A-2 FlashPoint™ LT BT-930 User’s Manual
Q. How can I use a CDROM drive with Mylex controller
card in MS-DOS?
A. In DOS, make sure the SCSI ID for the CD-ROM is higher than the disk
SCSI ID. Connect the CD-ROM in the SCSI chain so that it is properly
terminated. Then add these two lines to your CONFIG.SYS.
device=c:\path\flashpt.sys /d
device=c:\path\btcd-rom.sys /d:mscd001
Add this line in your AUTOEXEC.BAT:
c:\dos\mscdex.exe /d:mscd001
Q. When I load the FLASHPT.SYS driver in the DOS
CONFIG.SYS, the system hangs.
A. Do followings:
1. Make sure the IRQ settings are configured properly. In the system
CMOS under PCI option, there is an IRQ setting. Make sure an IRQ is
being assigned to the Mylex slot.
2. Try a different IRQ. For example, if you are using IRQ 12, try IRQ 11.
Make note of the first requirement above, make sure it applies when
you try a different IRQ.
3. Get another copy of the latest version of FLASHPT.SYS and try it. The
original file may be corrupted. Copies of this file can be obtained in our
BBS, FTP site, or WWW page.
Q. Why I am getting slow transfer times with my new
FAST SCSI-2 hard drives.
A. Make sure the drive is jumpered FAST SCSI-2 and active termination.
Also check that the controller has both Synchronous Negotiation and Fast
Data Transfer enabled.