Mylex FlashPoint BT-930, Руководство по установке и инструкция пользователя

Страница: 52 / 70

Troubleshooting Startup
4-4 FlashPoint™ LT BT-930 User’s Manual
NO BIOS BANNER IS DISPLAYED
The system does not find the adapter. Make sure the adapter is properly
installed in a busmaster slot.
SCANNING BUS...CARD XXX, SLOT X, BUS:XXX PORT XXXXX
If the system hangs with this message, the bus scanning operation did not
complete successfully. Check the following:
• Verify all the cables and connectors are firmly seated and properly
installed.
• Verify there are no reversed cable connections.
• Verify the FlashPoint adapter is installed in a busmaster slot.
• Verify all the devices, including the FlashPoint adapter, have unique
SCSI IDs.
BIOS NOT INITIALIZED.
NO SCSI TARGETS RESPONDED.
This message indicates that no SCSI devices have been detected:
• Verify the SCSI devices are properly cabled and connected.
• Verify all external devices are powered on.
• Verify all internal devices are connected to the power supply.
ENTERING CARD DIAGS/INIT, CARD:00
ERROR: ADAPTER CONFIGURATION FAILURE.
DIAGS: SCSI BUS FAILURE, CHECK CABLES!
This message indicates that the SCSI bus has failed the diagnostic test. Test
failure is often due to improper connections or bad cables. Do the following:
• Turn the system off and then on again. This action retries the diagnostic
test.
• Verify all cables and connectors are properly installed.
• Verify there are no reversed cable connections.
ENTERING CARD DIAGS/INIT, CARD:00
ENTERING SCSI BUS RESET PROTOCOL.
ENTERING SCSI BUS INTEGRITY TEST.
ENTERING SCAM SELECTION.
If the system hangs at this point in the diagnostic tests, check the following:
• There may be a SCSI ID conflict, verify that each SCSI device has a