Mylex FlashPoint BT-930, Руководство по установке и инструкция пользователя

Страница: 49 / 70

Manual No. 3000863 4-1
Chapter 4
Troubleshooting
Troubleshooting Guidelines
If you experience a problem with adapter operation when all the installation
steps are completed, refer to the following guidelines.
Check the Installation Procedures
• Be sure all connectors are firmly seated.
• Check the orientation of the SCSI cable. Be sure that Pin 1 on the cable
matches Pin 1 on the adapter/SCSI device connector.
• Check that the adapter and attached devices have unique SCSI IDs.
• Be sure that the SCSI ID for the boot hard drive is the same as the ones
in the AutoSCSI option. If the ID 0 (zero) is specified in that option,
BIOS determines the boot drive by scanning SCSI devices starting
from ID 0. If the boot drive number is higher than the other drive,
change it to a lower value.
• Be sure that you’ve followed SCSI termination rules.
• Check that you have correctly set the CMOS hard drive option to not
installed in your system SETUP file.
Verify Host Adapter Configuration Settings
☛
Note
Although IRQ and BIOS Addresses are automatically
configured in a PCI system, differences in PCI bus
implementation may result in conflicts among
adapters from more than one manufacturer.
• Check the adapter’s IRQ setting. Verify that each installed card has a
unique IRQ value. There may be a conflict with ISA (non-PCI)
adapters. If this occurs, you must change the non-PCI adapter’s IRQ
setting.