Mylex FlashPoint BT-930, Руководство по установке и инструкция пользователя

Страница: 33 / 70

Adapter and Device Configuration
Manual No. 3000863 3-7
Table 3-2. Adapter Configuration Option Descriptions
Option Value Description
Adapter SCSI ID 0- 7 Use this option if you need to change the
adapter’s SCSI ID on the SCSI bus. This ID
should remain unchanged, even where
there are multiple SCSI adapters, unless the
adapters are attached to a common SCSI
bus cable.
Boot Hard Disk SCSI ID 0 -7 The SCSI ID of the Boot Drive. If the value
is set to 0, then BIOS will boot from the first
SCSI ID starting from 0, that is included in
the BIOS scan.
CD-ROM Boot Supports ON
OFF
This setting indicates whether a CD-ROM
drive is supported as a boot drive.
Map Removal as Fixed ON
OFF
If the setting for this parameter is set to
OFF
(the default), removable drives (SyQuest or
Bernoulli for example) will not be attached
by the BIOS to a DOS drive at Boot time. If
the parameter is set to
ON , removable
drives will be attached to a DOS drive letter
if media is present at Boot time.
Floptical Support ON
OFF
When this option is set to
ON
, the BIOS
registers and controls floptical devices. Turn
this option
OFF if you have application
software to control floptical devices.
BIOS Support for 2+ HDD
ON
OFF
When enabled, DOS 5.x or later supports
two to eight devices without drivers.
INT 13h Extension ON
OFF
For Windows 95 this parameter supports
devices with capacities greater than 8
Gigabytes.