Mylex FlashPoint BT-930, Руководство по установке и инструкция пользователя

Страница: 20 / 70

Installing Your FlashPoint
2-6 FlashPoint™ LT BT-930 User’s Manual
Figure 2-3. Installing Internal Devices and Cables
When installing one internal device, connect it to the end of the cable and
terminate the device. Consult the owners manual for information on how to
terminate the device.
If a second internal device is to be included in the internal installation,
terminate only the device at the end of the cable. If the default configuration
for the device in the middle of the cable is terminated, consult the owner’s
manual to find out how to disable termination.
Be sure each device has a unique SCSI ID assigned. See “Setting the SCSI
Device ID” on page 2-2 in this chapter for more information about assigning
SCSI IDs.
Install the LED Cable (Optional)
Insert the connector from the drive activity LED on the front panel of the
host to the connector on the FlashPoint as shown in Figure 2-4. This
connector is reversible and may be plugged into the connector in either
direction. If your system has a two-pin LED drive activity connector, use the
first two or the last two pins. The following diagram shows the connector
pin-outs.