User’s Guide Rockhopper 3 Extreme
CHAPTER 5 : PREPARATIONS BEFORE PRINTING
62
AP-75198– Rev. 1.2
5.3.2 How to determine and change the step
Step 1 :
Power ON the printer.
Step 2 :
Load the media to print on.
Notes
B
E SURE TO TIGHTEN THE MEDIA TO THE WINDER
100
BEFORE SETTING THE STEP
. T
HIS BECAUSE THE STEP WILL BE
DIFFERENT WHEN PRINTING ROLL
-
TO
-
SHEET THAN WHEN PRINTING ROLL
-
TO
-
ROLL
.
Step 3 :
Perform a NozzleCheck to be sure all nozzles are present. If not, perform the necessary
cleanings.
Step 4 :
Set the step to 100.00%
Step 5 :
Print the test pattern. (SetupMenu 1/7 > TestPrint [F3] > Dist.Check [F2])
Step 6 :
To evaluate the print, you should look for gaps or overlaps between the different passes (1-4).
The direction of the adjustment (increase or decrease the step adjust value) is the easiest to
check in the X-rows. To check the quality, the Y rows should be the standard.
Содержание Rockhopper 3 Extreme
