User’s Guide Rockhopper 3 Extreme
CHAPTER 7 : TROUBLESHOOTING
134
AP-75198– Rev. 1.2
7.4 WHEN MEDIA JAMS OCCUR
If the loaded media gets jammed in the printer, follow the steps below to remove the media.
7.4.1 How to remove a piece of media (cut media)
Press [F4] to raise the pressure rollers.
The MEDIA SET lamp will switch ON (orange).
The following message is displayed on the operation panel.
Notes
For raising or lowering the pressure rollers, you can use the foot switch instead of the operation panel.
If a piece of media or media dust is stocked in the printer, open the front cover and remove the piece of
media or media dust.
Caution
Be sure not to pinch your fingers while opening and closing media cover.
1
Front Cover
If there is an error requiring a restart, power the printer OFF and ON again.
7.4.2 How to remove a piece of media (roll media)
To remove a piece of roll media, please refer to the Users Guide Handling roll media.
Содержание Rockhopper 3 Extreme
