User’s Guide Rockhopper 3 Extreme
CHAPTER 3 : BASICS
26
AP-75198– Rev. 1.2
3.1 POWERING ON CYCLE
Caution
B
EFORE POWERING
ON
THE PRINTER
,
MAKE SURE THAT THE WASTE BOTTLE IS INSTALLED AND THAT THE WASTE
TUBES ARE CONNECTED TO THE WASTE BOTTLE
.
Power ON the printer according to the procedure below:
Step 1 :
Press the [POWER] key of the operation panel.
The POWER lamp of the operation panel will light (green).
Step 2 :
The printer will ask if you want to clean the wipers. When it is the first start up in a few hours, it is
highly recommended to press [YES]
[F2] and to clean the wipers with Mutoh Mild cleaning in
order to remove all ink and to make the wipers more elastic.
Step 3 :
Press the ENTER key when you have done. The carriage will cap in again.
Step 4 :
After finishing the daily maintenance, the print will automatically perform a normal cleaning.
Step 5 :
After finishing the cleaning cycle, the media measurement screen will be displayed (in case there
is media loaded)
Содержание Rockhopper 3 Extreme
