Muratec FAX SCANNER, Руководство по установке

Страница: 117 / 187

Advanced fax
Setting for use with a closed network
For maximum communications security, use a closed network. This limits your
machine to only communicating with other Muratec fax machines which can “pre-
sent” the proper passcode.
Important: The passcode you use for closed network operation is not the same as
the protection passcode.
Once your machine is set up for a closed network, your machine will disconnect calls
coming in from fax machines other than Muratec fax machines.
To set your fax machine’s closed network password:
1
Decide on the four-digit closed network passcode (0001–9999) you want to use.
Write it down, and put it in a safe place.
2
Press
MENU
,
J
, 0, 8, [Enter].
The
LCD
shows the current code:
3
Use the numeric keypad to enter the desired
four-digit closed network passcode.
4
Press [Enter] to save the setting.
Note: To turn off the closed network passcode and return to normal fax reception,
change the code to 0000 by repeating steps 1–4 and entering 0000 in step 3.
To set your fax machine to operate in a closed network:
1
Press
MENU
,
J
, 0, 9, [Enter].
The
LCD
shows your fax’s current setting:
2
Select desired mode.
3
Press [Enter] to save the setting.
Setting Block Junk Fax
Your fax machine’s Block Junk Fax feature lets you bar the gates against unautho-
rized incoming faxes (“junk fax”). But before you block junk fax, first understand
how this feature works, to determine if it’s right for you. There are four possible set-
tings for Block Junk Fax:
• Off — The feature isn’t activated.
• Mode1 — Your fax machine checks whether the last four digits of any phone
number in your autodialer matches the last four digits of the remote fax’s sub-
scriber
ID
(the phone number part of the
TTI
). If it doesn’t find a match, your
machine disconnects the call.
• Mode2 — This mode rejects any call from a number whose last eight digits
match any number in the blocked numbers list (explained later). Your machine
can hold up to 30 blocked numbers.
• Mode3 — This rejects numbers that are not in the autodialer and also rejects num-
bers that are in the blocked numbers list. This lets you keep a number on your
autodialer for transmission to it, while still blocking its incoming calls by putting
it in the blocked numbers list.
But before you activate the Block Junk Fax feature, please consider:
• Not all fax machine owners enter their phone numbers in their Subscriber
ID
s. —
With Block Junk Fax activated, your machine would reject faxes from these
machines.
• Access codes can cause confusion. — If an autodialer entry ends with extra codes,
such as long-distance codes, Block Junk Fax will block out calls from those faxes.
To set Block Junk Fax:
1
Press
MENU
,
J
, 1, 1, [Enter].
The
LCD
shows your fax’s current setting:
2
Select desired mode.
3
Press [Enter] to save the setting.
What you do next depends on what you selected
in step 2:
• If you selected Off or Mode1, press
RESET
to return to standby mode.
• If you selected either Mode2 or Mode3, go on to step 4.
11.Block Junk Fax
Use cursor to select
desired mode.
OFF
Mode1
Mode2
Mode3
Enter
09.Closed Network
Use cursor to select
ON or OFF.
OFF
Enter
ON
08.Passcode
Enter
Enter the passcode.
0 000
Passcode :0000
3.65
F
ax F
eatures
Getting Started