Chapter 2 – Installation
22
MultiConnect AW User Guide
1.
Connect the antenna to the ANT connector on the back of the unit and tighten by hand.
WARNING
: Using a wrench to tighten the antenna or tightening the antenna above 7 inch-pounds may cause
the connector to spin, which can cause the solder connection between the coax and connector to
fail.
2.
Connect the DE9 connector (9-pin) of the RS232 cable to the COMMAND connector on the unit and connect
the other end to serial port on your PC.
3.
Connect the RJ11 phone cable to the DIAL connector on the unit and connect the other end of the phone
cable to the analog modem.
4.
Remove the protective shipping cover. Attach the appropriate input connector to the power supply device by
holding down on the slide lock and tipping the input connector to fit into the notch on top of the device and
then lowering it into the slide lock. Then release the slide lock.
5.
Screw on the power lead from the power supply device to the power connection on the unit. Now, plug the
power supply into your power source.
Note:
If desired you can press the Reset button to reset the hardware.
Optional – Attach the Modem to a Flat Surface
The modem can be panel mounted with screws spaced according to the measurement shown.
Note:
Use a #6 pan head screws for all mount locations.
