MSA VAUTEX ELITE 3S-L, Руководство пользователя

Страница: 10 / 64

10
GB
GB
Fig. 11
Tighten the screws in couples, starting from the centre.
Torque : 100 ± 10 Ncm.
Fit and tighten the fixing clamp for the mask connector.
Carry out the tightness test for the mask using the MSA AUER
mask tightness check kit (see catalogue number). Then carry out
the tightness test for the suit as given in section 5.4.
6.4 Replacing the gloves
6.4.1 Disassembly of the outer gloves

Take off the elastic cuffs and then remove the outer gloves.
6.4.2 Assembly of the outer gloves
 Pull the outer glove over the inner glove. The inner edge of the
outer glove must be fitted into the groove of the ring. After this
reposition the elastic cuffs.
6.4.3 Disassembly of the inner gloves
 Open the zipper completely.

Turn the sleeves of the protective suit inside out.

Loosen the fixing clamp (13).
 Pull out the tube (10) with the rubber ring (11).
 Pull out the glove (9).
6.4.4 Assembly of the inner gloves

Insert the tube into the glove cuff.

Insert the glove with the tube into the sleeve.
 Align the glove.
 Position the clamp and tighten – torque: 400 ± 30 Ncm
Attention!
The clamp lock must be on the same side as the thumb and
the clamp protector must cover the clamp lock.

Then check the protective suit for tightness.
Fig. 12
6.5 Replacing the boots
6.5.1 Disassembly of the boots
 Remove the rubber tube cover from the boot
 Completely open the zipper of the protective suit.

Turn the leg of the suit inside out.

Loosen and remove the clamp (20).
 Pull out the tube (22).
 Pull out the boot (24) from the suit leg.
6.5.2 Assembly of the boots

Push the boot into the suit leg that was turned inside out.

Align the suit leg and the boot.
 Insert the tube into the boot.
 Position the clamp and tighten it – torque: 500 ± 30 Ncm.

Position the tube cover onto the boot.