69
Maintenance and Service
ALTAIR io360
US
(3) Separate the front and back housing.
a) If needed, gently insert the slottted screwdriver into the slots
shown.
Do not exceed more than ¼" of penetration.
b) Do not pry where the shield attaches.
c) Rotate screwdriver apart slightly at each appropriate pry location.
(4) Remove battery holder retaining screws.
(5) Separate front housing from battery holder.
(6) Remove old sensor gasket.
Dispose of sensor gasket following local regulations.
(7) Gently remove the horn.
Do not pry in any manner to remove the horn.
(8) Ensure that the horn area is free of debris before installing.
Align terminals as shown below and gently install the horn until fully
seated. Positive terminal is oriented towards the lower part of the
detector.
(9) Replace the sensor gasket.
