MD-124 HW Manual
On-screen Display and Display Configuration
B-9
Display-Picture-PIP/PBP Adjust-PIP Picture-Contrast
To enable this function, please see
Display-Source-PIP-xxxx
, below.
This increases/decreases the overall contrast of the window overlay. This will not change the contrast of the
Main
Source
signal behind the window overlay. It can be used for situations where the incoming video signal from CCTV
or other video sources appears washed out in comparison to the source signal.
Scale is from 0-100. 50 is the default.
Display-Picture-PIP/PBP Adjust-PIP Picture-Sharpness
To enable this function, please see
Display-Source-PIP-xxxx
, below.
This increases/decreases the overall image sharpness. This will not change the sharpness of the Main Source signal
behind the window overlay. Use it to increase the visual quality of signals from possible older equipment or
electronically weak signals.
Scale is from 0-15 steps. 7 is default.
Display-Picture-PIP/PBP Adjust-PIP Picture-Color
This only applies to analog VIDEO IN signals.
To enable this function, please see
Display-Source-PIP-xxxx
, below.
This increases/decreases the overall color saturation for video signals. Can be used if the incoming signal lacks
strong colors because it originates in older equipment, or is transmitted over bad cables. This will not change the
color saturation/intensity of the
Main Source
signal behind the window overlay. Note that this function can also
make noisy color signals appear crisper/clearer if the parameter is reduced towards the grayscale.
Scale is from 0-100. 50 is the default.
Display-Picture-PIP/PBP Adjust-PIP Picture-Tint
This only applies to analog VIDEO IN signals.
To enable this function, please see please see
Display-Source-PIP-xxxx
, below.
This increases/decreases the overall video tint (applies only for NTSC video signals.), making all colors brighter or
darker. This may make the image appear washed out or stronger in terms of color intensity. Can be used if the
incoming signal from older equipment or bad cables lacks strong colors. This will not change the color tint of the
Main Source
signal behind the window overlay.
Scale is from 0-100. 50 is the default.
Picture: Advanced Settings
Display-Picture-Adv Settings-Color Temperature- xx00K
This adjusts the overall color temperature, as measured in Kelvin degrees. You can choose between 9300K and
6500K. This applies to the Main Source signal.
Window overlays (PIP/PBP)
and the
OSD Menu
overlay will be
unaffacted. Lower values make the image appear warmer, while higher values will make it appear cooler. Default is
set to 6500K. Please refer to the Kelvin color temperature scale below (approximate and symbolic):
When selected, a box icon (
█
) will indicate that the selected function has been activated.
