MD-124 HW Manual
On-screen Display and Display Configuration
B-16
Main Source
,
Second Source
,
Swap Source
. The assignment
No Function
eliminates all hotkey assignments
for the right/left arrows, leaving them (per default) only effective when the
OSD Menu
is activated.
When selected, a box icon (
█
) will indicate that the selected function has been activated.
Display Setup: Service Menu
Display-Setup-Service Menu-Type and Serial
This is only available in
Full Menu
mode.
This menu item reports the display unit’s
model
and
serial number
. This information is stored electronically,
on-board. Example:
MD-119ABCD12345678
: the model number forms the first five numbers, and the remaining
digits form the serial number.
Display-Setup-Service Menu-Firmware Ver
This is only available in
Full Menu
mode.
This menu item reports the device’s firmware version. Firmware updates may only be undertaken by a Moxa
engineer. If a firmware revision or customization is required, please contact Moxa’s customer support to learn about
our Professional Design Service (PDS).
Example: “V.10 S15”.
Display-Setup-Service Menu-Elapsed Time (Hours)
This is only available in
Full Menu
mode.
This function reports the total hours the display panel has been running since it was first installed; this is not the
same as how long the display has been powered up: the total time spent displaying an image since installation is
reported, and only time spent actually displaying an image is included. With reference to the device’s MTBF, this
menu item may be used to calculate the remaining life span of the device.
As an example, if the number
452
is displayed, here, then the device has been displaying images for a total of 452
hours.
Display: Input Sources / Dual Image Displays
Display-Source-Single-xxx
This menu item allows users to configure the display to display a single, solitary source input, without any
picture-in-a-picture or picture-by-a-picture configuration.
After navigating to
Display/Source
, upon selecting
Single
from the menu offered you will be transferred to a
submenu from which you may then select which signal source should be configured as the sole input signal to be
displayed. A small, square icon (
█
)
will appear next to whichever menu item is selected to indicate the currently
configured signal source.
Whichever source is selected as the single display will automatically be configured as the
Main Source
. This means
that, should the
Swap Source
feature be selected, the input source configured through the
Display-Source-Single
function will be switched out with whichever composite input signal (Composite 1, 2, or 3)
has been configured as the
Second Source
. Consequently, because the display controller has been previously
configured for
Single
mode, the currently configured
Main Source
image will disappear and be replaced with the
Second Source
(which will become the new
Main Source
). To return the device to its original configuration,
simply select
Swap Source
once again and the display controller will return to its original display configuration.
Choosing “single” will display only the input signal that has been configured as
Main Source
.
To change the signal source that is used in single mode, navigate into the submenu as before (i.e., by using the right
arrow to select
Single
from within the
Display/Source
menu) and choose which input signal should be prioritized
as the
Main Source
.
