MD-124 HW Manual
On-screen Display and Display Configuration
B-18
selected as the
Main Source
) will be displayed as the main image. To return the display to its original configuration,
simply select
Swap Source
once again and the display controller will return to its original display configuration.
If, after configuring a PBP, the menu item
Display-Source-Single
is activated (and the
Swap Source
function has
not been activated) then the PBP will disappear, leaving only the
Main Source
input signal as a solitary display.
When selected, a box icon (
█
) will indicate that the selected function has been activated.
Power Off
Display-Power Off
This function will perform a (soft) power down (i.e., turns off) the unit, shutting down the display controller and
cutting internal power to all components except the power module. When power is shut off the unit will enter
standby mode, whereupon the red, left-most LED will illuminate, while the green, right-most LED will go dark.
Please note that so long as the power cable is still physically connected to the power module power will
still be present in the unit.
Press the right (
►
) button to activate. A confirmation dialog will appear. Use
↑
/
↓
to confirm.
