Motrona CT340, Руководство по эксплуатации

Страница: 5 / 42

CT34002a_e.doc / Nov-15 Page 5 / 42
2. Introduction
The CT340 / CT641 units are suitable for control of rotating cutter systems, partial printing
screens and rotating punching or sealing applications.
The CT340 / CT641 units have been designed for the special requirements of these rotating
systems, under consideration of maximum efficiency and accuracy, with minimum stress for all
mechanical parts. Very short control cycles together with intelligent motion profiles provide
excellent performance under all operating conditions.
The units are very easy to set up. All settings can be made either by keypad and display at the
unit or by PC, with use of the motrona operator software OS3.2.
All relevant operational parameters and variables are accessible by RS232/RS485 interface. For
PROFIBUS applications, our PB251 gateway is available. Therefore the user has multiple
possibilities for remote control of all batch and cutting parameters via operator terminals, PC or
PLC systems.
The units are suitable for control of cutting applications as well as for partial printing screens
and rotating punching or sealing applications. This manual always says “cutting“ or “cut“ and
the reader may replace this by “printing“, “punching” or “sealing” when applicable.

This manual first provides all basic instructions for operation of model CT340

For operation of relays and thumbwheels with model CT 641 see appendix

For PC setup our “OS32” software is available on the CD included to delivery,
or on our homepage
www.motrona.com

For communication by PLC or IPC or by a remote operator terminal, please
observe the serial protocol details described in our separate manual “Serpro”.

PROFIBUS communication is possible with use of our gateway PB251.