CT34002a_e.doc / Nov-15
Page 18 / 42
6.2.
Description of the Parameters
Prior to register setting you must decide which dimensions or length units (LU) you like to use
for preset of the cutting length. This could be 0.1mm or 1mm or 0.001 inch or any other
resolution you desire. All further settings refer to the Length Units you decided to use. E.g.
when you chose to set the length with a 0.1 mm resolution, 1000 LUs will represent a length of
100.0 millimeters with all further entries.
6.2.1.
Length Setting
F01
Range
Default
F01.000 Cutting Length:
Preset of the desired cutting length scaled in length units.
1 … 999999
10000
6.2.2.
Operational Settings
F02
Range
Default
F02.002 Circ. Master:
This register must be set to the circumference of the line
feed roll or the measuring wheel of the line encoder.
Setting in length units you decided to use.
1 … 99999
1000
F02.003 PPR Master:
Pulses per revolution of the line encoder.
Enter the number of pulses from the encoder for one
revolution of the feeding roll or measuring wheel with
regard to the multiple edge count setting (x1, x2, x4).
1 … 999999
1000
F02.004 Circ. Cutter:
Circumference of the cutting roll scaled in length units.
1 … 99999
1000
F02.005
PPR Cutter:
Pulses per revolution of the cutting roll.
Enter the number of pulses from the encoder for one
revolution of the cutting roll with regard to the multiple
edge count setting (x1, x2, x4).
1 … 999999
1000
F02.006 Trim Time:
Adjustment time for one increment of cut position
displacement with use of the Trim function.
To be entered as number of cycles (1 cycle = 250 µsec)
per increment.
001 = Displacement of one increment each 250 µs
(fast)
999 = Displacement of one increment each 0.25 s
(slow)
1 … 999
100
