Motorola EX-3524, Справочное руководство CLI

Страница: 456 / 617

Chapter 19
| Quality of Service Commands
– 456 –
Example
This example creates a policy called “rd-policy,” uses the class command to specify
the previously defined “rd-class,” uses the set phb command to classify the service
that incoming packets will receive, and then uses the police flow command to limit
the average bandwidth to 100,000 Kbps, the burst rate to 4000 bytes, and configure
the response to drop any violating packets.
Console(config)#policy-map rd-policy
Console(config-pmap)#class rd-class
Console(config-pmap-c)#set phb 3
Console(config-pmap-c)#police flow 100000 4000 conform-action transmit
violate-action drop
Console(config-pmap-c)#
service-policy
This command applies a policy map defined by the policy-map command to the
ingress side of a particular interface. Use the no form to remove this mapping.
Syntax
[ no ] service-policy input policy-map-name
input - Apply to the input traffic.
policy-map-name - Name of the policy map for this interface.
(Range: 1-32 characters)
Default Setting
No policy map is attached to an interface.
Command Mode
Interface Configuration (Ethernet)
Command Usage
◆
Only one policy map can be assigned to an interface.
◆
First define a class map, then define a policy map, and finally use the service-
policy command to bind the policy map to the required interface.
◆
The switch does not allow a policy map to be bound to an interface for egress
traffic.
Example
This example applies a service policy to an ingress interface.
Console(config)#interface ethernet 1/1
Console(config-if)#service-policy input rd-policy
Console(config-if)#