Motorola EX-3524, Справочное руководство CLI

Страница: 447 / 617

Chapter 19
| Quality of Service Commands
– 447 –
■
set cos command sets the class of service value in matching packets.
(This modifies packet priority in the VLAN tag.)
■
set ip dscp command sets the IP DSCP value in matching packets.
(This modifies packet priority in the IP header.)
■
police commands define parameters such as the maximum throughput,
burst rate, and response to non-conforming traffic.
◆
Up to 16 classes can be included in a policy map.
Example
This example creates a policy called “rd-policy,” uses the class command to specify
the previously defined “rd-class,” uses the set phb command to classify the service
that incoming packets will receive, and then uses the police flow command to limit
the average bandwidth to 100,000 Kbps, the burst rate to 4,000 bytes, and
configure the response to drop any violating packets.
Console(config)#policy-map rd-policy
Console(config-pmap)#class rd-class
Console(config-pmap-c)#set phb 3
Console(config-pmap-c)#police flow 100000 4000 conform-action transmit
violate-action drop
Console(config-pmap-c)#
police flow
This command defines an enforcer for classified traffic based on the metered flow
rate. Use the no form to remove a policer.
Syntax
[ no ] police flow committed-rate committed-burst
conform-action transmit
violate-action { drop | new-dscp }
committed-rate - Committed information rate (CIR) in kilobits per second.
(Range: 64-1000000 kbps at a granularity of 64 kbps or maximum port
speed, whichever is lower)
committed-burst - Committed burst size (BC) in bytes.
(Range: 4000-16000000 at a granularity of 4k bytes)
conform-action - Action to take when packet is within the CIR and BC.
(There are enough tokens to service the packet, the packet is set green).
violate-action - Action to take when packet exceeds the CIR or BC. (There
are not enough tokens to service the packet, the packet is set red).
transmit - Transmits without taking any action.
drop - Drops packet as required by violate-action.
new-dscp - Differentiated Service Code Point (DSCP) value. (Range: 0-63)