Motorola EX-3524, Справочное руководство CLI

Страница: 107 / 617

Chapter 4
| System Management Commands
Line
– 107 –
speed
This command sets the terminal line’s baud rate. This command sets both the
transmit (to terminal) and receive (from terminal) speeds. Use the
no form to
restore the default setting.
Syntax
speed bps
no speed
bps - Baud rate in bits per second.
(Options: 9600, 19200, 38400, 57600, 115200 bps, or auto)
Default Setting
auto
Command Mode
Line Configuration
Command Usage
Set the speed to match the baud rate of the device connected to the serial port.
Some baud rates available on devices connected to the port might not be
supported. The system indicates if the speed you selected is not supported. If you
select the “auto” option, the switch will automatically detect the baud rate
configured on the attached terminal, and adjust the speed accordingly.
Note: Auto-detection of baud rate is only performed at user log in.
Note: Due to a hardware limitation, the terminal program connected to the
console port must be set to 8 data bits when using auto baud rate detection.
Example
To specify 57600 bps, enter this command:
Console(config-line)#speed 57600
Console(config-line)#
stopbits
This command sets the number of the stop bits transmitted per byte. Use the no
form to restore the default setting.
Syntax
stopbits { 1 | 2 }
no stopbits
1 - One stop bit
2 - Two stop bits