Motorola EX-3524, Справочное руководство CLI

Страница: 147 / 617

Chapter 5
| SNMP Commands
SNMPv3 Commands
– 147 –
◆
For additional information on the notification messages supported by this
switch, see the table for “Supported Notification Messages” in the
System
Reference Guide . Also, note that the authentication, link-up and link-down
messages are legacy traps and must therefore be enabled in conjunction with
the
snmp-server enable traps command.
Example
Console(config)#snmp-server group r&d v3 auth write daily
Console(config)#
snmp-server user
This command adds a user to an SNMP group, restricting the user to a specific
SNMP Read, Write, or Notify View. Use the
no form to remove a user from an SNMP
group.
Syntax
snmp-server user username groupname [ remote ip-address ]
{ v1 | v2c | v3 [ encrypted ] [ auth { md5 | sha } auth-password
[ priv des56 priv-password ]]
no snmp-server user username { v1 | v2c | v3 | remote }
username - Name of user connecting to the SNMP agent.
(Range: 1-32 characters)
groupname - Name of an SNMP group to which the user is assigned.
(Range: 1-32 characters)
remote - Specifies an SNMP engine on a remote device.
ip-address - The Internet address of the remote device.
v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
encrypted - Accepts the password as encrypted input.
auth - Uses SNMPv3 with authentication.
md5 | sha - Uses MD5 or SHA authentication.
auth-password - Authentication password. Enter as plain text if the
encrypted option is not used. Otherwise, enter an encrypted password.
(Range: 8-32 characters)
priv des56 - Uses SNMPv3 with privacy with DES56 encryption.
priv-password - Privacy password. Enter as plain text if the encrypted
option is not used. Otherwise, enter an encrypted password.
(Range: 8-32 characters)
Default Setting
None