MOTO GUZZI CALIFORNIA EV 1997-2000, Руководство по ремонту, Страница: 85 / 288

A
B
C
D
E
F
G
H
I
L
M
N
O
P
4 W
HEEL PARTS
D
C
A
R
EMOVAL
1 (W
ITH THROUGH WHEEL SHAFT AND BACK
NUT
)
• Place the vehicle on the centre stand (if available).
• Place anyway a support under the motorbike to lift
the front wheel from ground.
• Unscrew screws “D” fixing the caliper (J
ACKAL
- S
TONE
)
or the calipers (EV - S
PECIAL
- S
PECIAL
S
PORT
) to the
fork leg.
• Remove the caliper/s from the brake disks.
• Unscrew back nut “B” from the wheel shaft with the
proper wrench part no. 01929300 (see picture on page
2 of this section).
• Loosen the 4 fastening screws “C” between the shaft
and the fork leg.
• Remove shaft “A” with its spacers and then remove
the wheel.
Refer to chapter 3 of this section for wheel overhaul.
R
EASSEMBLY
1
After carrying out all necessary wheel checks, reassemble
as follows:
• Place the complete wheel between the fork legs.
• Lubricate the shank and the thread of the wheel shaft
with the suggested grease.
• Place the spacers and make the shaft rest on the
wheel hub.
• Lubricate the thread and the underhead of the lock
nut “B”, then screw it on the wheel shaft end.
• Tighten the 4 screws “C” to the prescribed torque.
• Lock the nut “B” to the prescribed tightening torque.
• Check that the disks run freely inside the calipers and
then operate the brake lever repeatedly to bring the
calipers pistons to the normal position.
B
A
C
D
E
F
G
H
I
L
M
N
O
P