MOTO GUZZI CALIFORNIA EV 1997-2000, Руководство по ремонту

Страница: 221 / 288

A
B
C
D
E
F
G
H
I
L
M
N
O
P
74 E
NGINE
A
R
EASSEMBLY
C
ONNECTING RODS
Carry out the removal procedures in reverse order,
remembering that:
• Given the high load and stresses to which the
fastening screws for the crankshaft connecting rods
are subjected, they must be replaced with new screws.
• The assembly backlash between the bearing and the
connecting rod pin is 0,022 minimum, 0,064
maximum;
• The backlash between the shimmings for the
connecting rods and those for the crankshaft is 0,30
÷ 0,50 mm;
• Tighten the screws on the caps using a torque wrench
to the torque prescribed in the table in chapter 4,
section B.
C
RANKSHAFT
Carry out the removal procedure in reverse order,
remembering to:
• Correctly position the crankshaft support flange,
following the assembly direction marked by the holes
“A”;
• Apply teflon tape on the two lower fastening screws
for the rear flange to avoid oil leakages.
B
A
C
D
E
F
G
H
I
L
M
N
O
P