Motion Control Engineering Nidec Element Series, Руководство пользователя

Страница: 153 / 199

Troubleshooting Reference
2-71
element
TM
Series
Heavy Load (47) The car is loaded beyond the heavy load setting. Under this condition, a
moving car will ignore additional hall calls until the load is reduced by
passenger departure. Fault-bypassed in Construction.
System Verifies:
- Status of input
- Load Data = Load Heavy
Correction:
1. If in error, verify no input is programmed for Load Hvy.
2. Otherwise, verify status of input and input device.
3. Verify input wiring.
4. Verify System IO > Programmed Inputs > Load Hvy.
5. Calibrate load weigher.
Hoist. Access Construct (58) The car is on construction operation and hoistway access. Cannot be
bypassed.
Correction:
1. Exit construction operation (
Construction Operation on page 1-8 ).
Hoist. Access Inspection (62) The car is on Inspection mode and hoistway access. Cannot be bypassed.
System Verifies:
- Mode of Operation = Inspection HA
Correction:
1. If in error, verify INA input.
In-Car Construct/Bypass (317) Car panel inspection and construction operation are active and one or
both of the Car/Hoistway Door Bypass switches is in the Bypass position.
Cannot be bypassed.
System Verifies:
- ModeOfOperation = OpModeConstructionBPCP
Correction:
1. Exit construction operation (
Construction Operation on page 1-8 )
In-car Construction (57) The car is operating in construction mode from the in-car controls.
In-Car Insp/Bypass (128) Car Panel inspection is active and one or both of the Car/Hoistway Door
Bypass switches is in the Bypass position. Cannot be bypassed.
System Verifies:
- ModeofOperation = OpModeInspectionBPCP
Correction:
1. Turn off one or both of the Car/Hoistway Door Bypass switches.
In-Car Inspection (61) The car is on Inspection mode and is being operated from the in-car
inspection station. Cannot be bypassed.
System Verifies:
- Mode of Operation = Inspection CP
Correction:
1. If in error, verify car panel inspection inputs.
Independent Mode (29) The car is running on independent mode and will not accept hall calls.
Cannot be bypassed.
System Verifies:
Mode of Operation = Independent
Correction:
1. If in error, verify no input programmed IND SERV if IND SERV not
available.
2. Verify IND SERV input and initiating device wired per job prints.
Table 2.15 Touch Screen Event Listings
Event Description