Motion Control Engineering Nidec Element Series, Руководство пользователя

Страница: 169 / 199

Troubleshooting Reference
2-87
element
TM
Series
SPC: SPB is Offline (227) Safety processor C reports that Safety Processor B is not communicating.
Car will perform an emergency stop and will not be allowed to move. All
calls will be canceled and doors will not be allowed to move. May occur
subsequent to an unsuccessful parameter update. Cannot be bypassed.
System Verifies:
- SPB sequence numbers offline
Correction:
1. Press the SCE-CPU board RSTB button.
2. If the processor resets, monitor activity for recurrence.
Stuck Car Call (104) A timer (10 seconds) limits the amount of time a car will be held at a
floor due to a defective or stuck car call. When the timer expires, call
demand at another floor will cause the defective call to be ignored and
the car will continue to provide service. Fault-bypassed in Construction/
Inspection.
System Verifies:
- Car Flags, Stuck Car Call Timer Front = Timer Elapsed
Correction:
1. Verify car call input not continuously activated. (See Register Calls
screen and/or programmed inputs.)
Stuck Door Open Button (161) The door open button has been detected as being pressed continuously.
Correction: Check door open button, door open button input and diag-
nostic flag for DOB under System IO > Programmed Inputs > screen 2.
Stuck Door Zone Fault (271) Door zone did not go low during run. Fault-bypassed in Construction/
Inspection.
Correction:
1. Verify activity.
2. Check wiring.
3. Verify DZ flag activity at Utilities > Landing System Utilities > Landing
System View to see that DZ turns off when car is between floors.
Stuck Down Hall Call (357) System has detected a sticking down hall call button.
Stuck Leveling Fault (273) Leveling signal did not transition low at end of run. ULM and DLM are
both active. Fault-bypassed in Construction/Inspection.
Correction:
1. Verify, UTILS > Landing System View > ULMF or DLMF.
2. Verify landing system function and wiring.
Stuck Photo Eye (159) Photo eye input continuously active. If Bypass Stuck PHE (Config 01) is
enabled, the controller will ignore the PHE and close the doors after the
Stuck PHE Timer elapses or when the Car Delayed timer expires, which-
ever comes first. Fault-bypassed in Construction/Inspection.
System Verifies:
- Door Flags = Stuck Photo Eye Timer Elapsed
- Door Flags, Photo Eye Bypassed and Photo Eye Failed are not true.
Correction:
1. Verify PHE status, System IO, Programmed Inputs.
2. If no PHE is installed, PHE input should not be programmed.
3. Verify function of PHE device.
Table 2.15 Touch Screen Event Listings
Event Description