Mooney M20V Acclaim Ultra, Руководство по эксплуатации для пилотов

Страница: 212 / 265

MOONEY
M20V ACCLAIM ULTRA
SECTION VII
AIRPLANE AND SYSTEM DESCRIPTION
7 - 9
AIRPLANE FLIGHT MANUAL ORIGINAL ISSUE - 03-16-2017
9. MASTER POWER SWITCH
Master switch operates battery relay which controls battery power (selected battery) to main
buss. This switch cuts ALL ship power OFF, except cabin overhead lights and baggage com-
partment light.
10. BATTERY SELECT SWITCH - BAT 1/BAT 2
This switch allows pilot to select either battery as primary for any flight. Battery #1 is normally
used for operations. The battery not being used is recharged through a trickle charge system.
It is recommended to switch batteries occasionally.
11. EMERGENCY BUS SWITCH (Optional when Stand- by Alternator is installed)
When Low Voltage annunciation illuminates, steady or flashing, pull 90A BAT circuit breaker
and PUSH EMERG BUS switch ON to bring Stand- by Alternator online.
12. STROBE LIGHT SWITCH
Strobe light switch turns wing tip and tail strobe lights ON.
13. NAVIGATION LIGHT (NAV LITE) SWITCH
Navigation light switch turns wing tip and tail navigation lights ON.
14. TAXI LIGHT (TAXI LITE) SWITCHES (L & R)
15. LANDING LIGHT (LDG LITE) SWITCHES (L & R)
Select and push split switches to turn desired set of lights ON. Push switches OFF to turn
desired set of lights off. Lights should be operated only for short time periods while not in flight
to preclude overheating of lamps. Overload protection is achieved by circuit breakers in pan-
el.
16. GEAR SAFETY BY PASS SWITCH (Gear Retraction Override)
Gear safety override switch is a manual means of electrically by-passing the Air speed Safety
Switch. In the event the landing gear switch is placed in gear-up position, a properly operating
Airspeed Safety Switch prevents gear from being retracted before take off speed of approxi-
mately 60

5 KTS is reached. To retract landing gear at a lower air speed, the GR SAFETY
BY PASS switch may be held de-pressed until landing gear is completely retracted.
Activation of landing gear safety override switch overrides the safety features of
airspeed safety switch and CAN cause landing gear to start retracting while aircraft
is on ground.
-CAUTION-
17. LANDING GEAR SWITCH
Electric gear switch, identified by its wheel shaped knob, is a two-position switch. Pulling aft
and lowering knob lowers landing gear while pulling aft and raising knob raises landing gear.
-NOTE-
Failure to “Pull” knob out prior to movement may result in a broken switch.
18. GEAR DOWN POSITION INDICATOR
The gear- down position indicator, located on floorboard near back of fuel selector valve pan,
aft of center console, has two marks that align when landing gear is down and illuminates
when GREEN GEAR DOWN annunciation is ON. A red-white striped decal shows when
landing gear is NOT in the down position.
19. RUDDER TRIM SWITCH
Spring loaded momentary switch to position rudder into trimmed condition to reduce rudder
pedal forces during take off, climbs or descents. Right - take off and climbs; Left - descents.
Turning left side of spring loaded switch trims rudder left, turning right side of switch trims
rudder right.
20. PITOT HEAT SWITCH
Pitot heat SWITCH turns on heating elements within pitot tube. “PITOT HEAT” annunciation
will illuminate “AMBER” only when failure occurs.