Moog G396-026, Руководство по эксплуатации

Страница: 43 / 85

Programmable Multi-Axis Servo Drive Power Supply Unit Operation Manual
ID no.: CA97556-001 Date: 03/2015
moog
43
Electrical installation
X11
+ – + –
X11
X11
+
–
X12
+ L3 L2 L1 PE –
-
RB
ZK
+
X11 X11 X11 X11
+ +
–
+
– – –
+
–
+
Power Supply Unit
size 6A
Multi-Axis Servo Drive size
5
Multi-Axis Servo Drive size 4
Multi-Axis Servo Drive size
3
Multi-Axis Servo Drive size 6A
Multi-Axis Servo Drive size
2
Multi-Axis Servo Drive size
1
Figure 3.20 Schematic: DC power supply connection size 6A to size 6A
Figure 3.19 Detail: Size 6A DC power supply connection to smaller Multi-Axis Servo Drives
Size 6A connection to size 6A Multi-Axis Servo Drives
Connect terminal X12/ZK+ of the Power Supply Unit to terminal X11/ZK+ of the next butt-
mounted Multi-Axis Servo Drive size 6A.
Use dedicated cables for the purpose.
The connection of the DC link must be made with parallel cables. The conductor cross-section
must be at least 50 mm 2 (0.08 in 2 ) (CU). The cables must be short-circuit and earth fault
proof, and shielded. Twist the cables or use a shield tube. A length of 2 m (6.56 ft) must not
be exceeded. If other cables are used, Moog can provide no guarantee of stable and safe
operation.
On the Multi-Axis Servo Drive connect the DC power supply conductor to the next butt-mounted
Multi-Axis Servo Drive.
Connect terminal X12/ZK- of the Power Supply Unit to terminal X11/ZK- of the next butt-
mounted Multi-Axis Servo Drive size 6A.
On the Multi-Axis Servo Drive connect the DC power supply conductor to the next butt-mounted
Multi-Axis Servo Drive.
Use dedicated cables for the purpose.
Connect the touch protection to DC link terminals X11.
For more information refer to the Multi-Axis Servo Drive Operation Manual.
1.
2.
3.