Moog G396-026, Руководство по эксплуатации

Страница: 38 / 85

Programmable Multi-Axis Servo Drive Power Supply Unit Operation Manual
ID no.: CA97556-001 Date: 03/2015
moog
38
Electrical installation
1) Mains fuses
2) Mains supply/emergency stop
3) Shield plates (grey)
4) Step-up choke with KTY temperature sensor
5) Above a cable length of >500 mm shielded cables should
be used
6) Input choke with membrane capacitor
7) Mains contactor (after precharge by HREL)
8) Mains filter
9) Short-circuit-proof cables
10) Circuit-breaker
11) Multi-axis system On/Off
12) External 24 V DC control supply
13) Auxiliary contactor (precharge/synchronisation)
14) Connection of DC link precharge and mains synchro-
nisation
15) Floating contact:250 V AC/5 A or 30 V DC/6 A (active
when precharge complete)
16) Power Supply Unit size 6A
17) AC power connection
18) Braking resistor
Figure 3.15 Connection of mains supply (schematic view)
ATTENTION!
Danger to life! Never wire or disconnect electrical connections while they are
live. Always disconnect the power before working on the device. Dangerously
high voltages ≥50 V (capacitor charge) may still be present 10 minutes after
the power is cut to the size 5 and size 6A. The discharge time depends on the
number of drives connected to the multi-axis system. So check that no voltage
is connected!
!
3.6.3 Mains connection 400/480 V AC (X12) for size 5 and
Size 6A
5
24 V DC
ZK RB
+ � � +
Power Supply Unit
+ � L1 L2 L3 N
nc
� + � + HREL
L1 L2
X12
X21
X5
X9/10 X11
L3
L1 L2 L3 PE
L3
L2
L1
L3. 1
L2. 1
L1. 1
L3.
1
L2.
1
L1.
1
L3 L2 L1
L3.
1
L2.
1
L1.
1
L3 L2 L1
L1. 1
L2. 1
L3. 1
L1
L2
L3
1
2
4
6
14
3
7
8 9 10
12
11
13
15
18
17
16
�