© MOOG 2019
This document is subject to MOOG INTELLECTUAL AND PROPRIETARY INFORMATION LEGEND . The details are on page II.
52
MRJ06301
STATUS INDICATORS
There are two status indicators on the [F1] profile page (Figure 2-9). The status can be checked as follows
depending on the status of the indicator.
Running or Ready
Die gap and Delay are not highlighted
Die gap
Die gap is highlighted
Delay
Delay is highlighted
Status Condition
Running or Ready:
1) When the mode is changed from MANUAL to
AUTO
2) When the power is turned on or the DigPack
Ⅲ
is
reboot
3) When the STOP signal is input
4) End of movement of the Delay to until Diegap sig-
nal ON.
Die gap:
From DieGap signal and while core on the Die gap position
Delay:
From Start signal and while Delay running
Figure 2-9 Status indicator
2-3-5. EDIT AREA
In the edit area shown in Figure 2-6, the detail screen when the specific function key [F1-F5] selected is
displayed.
Selection of the individual Function Items is done by the Cursor or touch directly. In Figure 2-9, the value
of the Item
Cycle time
, 10.0 sec, is highlighted and therefore
Cycle time
is selected. Turning the
Rotaly
Knob
will increase (CW) or decrease (CCW) the
Cycle time
value. To make this
Cycle time
change
permanent,
SET
must be pressed. If do not press SET and press ESC or move the cursor here, the value
of
Cycle time
will be restored. * For details of value input method, please refer to section 2-3-2.
Selection of other Function Items is done by repeatedly pressing the Up or Down
Cursor
until the desired
Item is reached or touch the item directly. In this manner, all of the individual Function Items may be
selected. The value of any Function Item will not be changed when moving between Function Items unless
SET
is pressed.
This input procedure applies to all Function screens.
Status indicator
