49-80267 Rev. 4
15
Installation Instructions
WALL-MOUNTED INSTALLATION—RECIRCULATING
3
PREPARE THE HOOD
■ Remove the hood from the box. Remove packaging
and tape.
■ Remove one screw on each side of the cover on
the electrical panel. Lift off the cover and set aside
with screws.
■ Stand the electrical panel upright.
■ Align the screw holes in the
bottom of the panel with the
holes on the base of the
hood at the front side.
■ Install 3 screws provided.
2
INSTALL MOUNTING BRACKET
This vent hood must be secured to the horizontal
support or wall studs.
■ With the template taped in place, use a punch to
mark all mounting screw locations.
■ Drill 1/8” pilot holes at the 6 punched locations.
■ Remove the template.
■ The 2 holes in the support bracket holes must enter
studs or the horizontal support.
■ Use wood screws to secure the mounting bracket to
the wall. The screws must engage wall studs or the
installed horizontal mounting support.
■ Check to be sure that the bracket is level. There is
no way to level the hood after hanging it from this
bracket.
Remove 2 side
cover screws
Electrical
panel
Secure electrical
panel with 3
screws
Junction box
Inside screw
1” = 2.5 cm; 1’ = 0.3 m