49-80267 Rev. 4
21
UNDER-CABINET INSTALLATION
Installation Instructions
3
CUT THE OPENING
If the cabinet has been installed, remove it from the
wall.
■ Use the Top Cabinet Template to locate and cut a
hole in the bottom of the cabinet.
■ If necessary, place the template on top of the
cabinet to accurately cut a matching hole.
■ Install the cabinet onto the wall.
The cabinet must be firmly secured to the wall
and be capable of supporting 100 lbs.
INSTALL WOOD BLOCKS IF NECESSARY
■ Install filler blocks whenever the cabinet frame
hangs below the cabinet bottom.
■ Install filler blocks whenever the cabinet bottom is
less than 3/4” thick.
■ Install the filler blocks on each side of the cutout.
The filler blocks will accept the hood mounting
screws.
NOTE:
Additional filler blocks may be required along
the outside edges to accept the outside screws. See
Step 5.
IMPORTANT:
If filler blocks are not used, the hood
may not be secured to the cabinet.
4
INSTALL SIDE “L” BRACKETS
■ Install the “L” brackets onto each side of the
cutout. The wide flat portion should be on top of
the opening. Install 2 screws into the top of each
bracket.
5
REMOVE SIDE SCREW
The top center screw on both sides of the hood
can be used to close up any noticeable gaps at the
outside edges. See illustration.
■ Remove the center screw cover and screw on each
side as shown.
Cabinet Frame.
Cabinet Bottom Shelf
Filler Block
Top of Vent
Hood
Equivalent
to Depth of
Cabinet Recess
Install 2 screws in each
bracket
Remove screw
cover and screw
1” = 2.5 cm; 1’ = 0.3 m
