26
AVFL Vent Free Fireplace
Monessen • AVFL42NIP-SR Installation Instructions • 4119-900 Rev. B • 05/20
IntelliFire™ Plus ODS
Figure 5. Programming RC300 - (Control Module is located under
unit.)
REMOTE POSITION
Programming the RC300 to the Control Module
CAUTION! RISK OF BURNS!
DO NOT PROGRAM THE
REMOTE CONTROL TO THE CONTROL MODULE WHEN
FIREPLACE IS HOT.
• Verify the ON/OFF/REMOTE switch is in the REMOTE
position. Green LED light will blink three times and
control module will beep once 5 seconds later when
ready. See Figure 5.
• Using a small item (such as a paper clip) press and
release the LEARN button located near the ON/OFF/
REMOTE switch. See Figure 5.
• Control module will beep once and LED will blink green
for 10 seconds.
• While the LED is blinking, press the POWER button on
the remote control. A double beep will come out of the
control module to indicate that it has been programmed
successfully.
NOTICE:
Up to three remote controls can be programmed
into the control module. Simply press a button on the other
remote controls during the 10 second programming process
to add another remote into the system. It is recommended
to program only one RC300 remote control.
To clear memory in the control module, use a small item
(such as a paper clip) to press and release the LEARN
button.
Control module will beep once and LED will blink
green for 10 seconds
DO NOT
press any buttons on the
remote during the ten seconds that the green LED blinks.
The memory will be cleared. Note that the RC300 will not
be programmed if it’s in STANDBY mode. Press the ON/
OFF button twice to switch to IDLE mode.
