22
AVFL Vent Free Fireplace
Monessen • AVFL42NIP-SR Installation Instructions • 4119-900 Rev. B • 05/20
OPERATING INSTRUCTIONS
4604-200
FOR YOUR SAFETY READ BEFORE LIGHTING
TO TURN OFF GAS TO APPLIANCE
1. Equipped with wall switch: Turn ON/OFF switch to OFF.
Equipped with remote or wall control: Press OFF button.
Equipped with thermostat: Set temperature to lowest setting.
WARNING
: If you do not follow these instructions exactly, a
fi
re or explosion may result causing property damage, personal injury or loss of life.
GAS
VALVE
A. This appliance is equipped with an intermittent pilot ignition (IPI) device which
automatically lights the burner.
DO NOT
try to light the burner by hand.
B.
BEFORE LIGHTING
, smell all around the appliance area for gas. Be sure to smell
next to the
fl
oor because some gas is heavier than air and will settle on the
fl
oor.
WHAT TO DO IF YOU SMELL GAS
•
DO NOT
try to light any appliance.
•
DO NOT
touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas sup-
plier’s instructions.
• If you cannot reach your gas supplier, call the
fi
re department.
C.
DO NOT
use this appliance if any part has been under water. Immediately call
a quali
fi
ed service technician to inspect the appliance and to replace any part of
the control system and any gas control which has been under water.
LIGHTING INSTRUCTIONS (IPI)
2. Wait
fi
ve (5) minutes to clear out any gas. Then smell for gas, including near the
fl
oor. If you smell gas, STOP! Follow “B” in the Safety Information located on the
top of this label. If you do not smell gas, go to next step.
3. To light the burner:
Equipped with wall switch: Turn ON/OFF switch to ON.
Equipped with remote or wall control: Press ON or FLAME button.
Equipped with thermostat: Set temperature to desired setting.
4. If the appliance does not light after three tries, call your service technician or gas
supplier.
2. Service technician should turn off electric power to the control when performing
service.
1. This appliance is equipped with an ignition device which automatically
lights the burner. DO NOT try to light the burner by hand.
4604-201
.
WARNING:
NOT FOR USE WITH SOLID FUEL
DO NOT CONNECT LINE VOLTAGE (110/120 VAC OR 220/240 VAC) TO THE CON-
TROL VALVE.
Improper installation, adjustment, alteration, service or maintenance can cause
injury or property damage. Refer to the owner’s information manual provided with
this appliance. For assistance or additional information, consult a quali
fi
ed installer,
service agency or the gas supplier.
This appliance needs fresh air for safe operation and must be installed so there are
provisions for adequate combustion and ventilation air.
Keep burner and control compartment clean. See installation and operating instruc-
tions accompanying appliance.
Hot while in operation. DO NOT touch. Keep children, clothing, furniture, gasoline
and other liquids having
fl
ammable vapors away.
,
e
n
o
n
fi
;
y
n
a
fi
,
s
e
d
o
c
l
a
c
ol
h
ti
w
e
c
n
a
d
r
o
c
c
a
ni
d
el
la
ts
ni
e
b
t
s
u
m
e
c
n
ai
lp
p
a
s
ih
T
follow the
National Fuel Gas Code, ANSIZ223.1/ NFPA 54, or the National Gas and
Propane Installation code, CSA B149.1.
CAUTION:
For additional information on operating your
Hearth & Home Technologies
fi
replace, please refer to www.
fi
replaces.com.
