2.5.5
USB Connection to a D12 Camera
1) Remove the two Allen screws of the
cable
cover
(3 mm Allen wrench) and lift off the ca-
ble cover.
Note:
If the cable cover cannot be removed
by hand, take a screwdriver to lift it out of its
seat. Insert the screwdriver into the grooves
shown below and gently lift
the cable cover.
2) Lead the MOBOTIX D12 USB cable with the
Mini USB plug first from the bottom of the
camera housing through the right-hand
opening and guide it around the camera
housing in counter-clockwise direction (as
seen from above). Make sure that this cable
is running properly as shown in the figures
below.
3) Insert the D Sub 15 HD plug of the MOBOTIX
D12 USB cable into the D Sub 15 HD connec-
tor of the MOBOTIX camera and properly
lead the cable through the guides at the
outer rim of the housing. Make sure that the
cable is running properly as shown in the fig-
ures below. The cables should cross one an-
other just before the connectors.
4) Remove the rubber plug from the cable guide before leading
the USB cable through the guide.
If you need to remove the USB cable again sometime, you will
need to reinsert the rubber plug into the cable guide. This will
ensure that the camera remains weatherproof (IP65).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [email protected]
40
/76
MOBOTIX ExtIO User Manual
USB cable (5 m/16 ft) for
MOBOTIX D12 and M12
models:
MX-CBL-HD-MU-5
3
mm Allen wrench is in-
cluded in the delivery of
the D12 cameras
Lead the cables through
the cable guides at the
outer rim of the housing
If you are only using one
cable, close the unused
cable guide with one of
the supplied plugs
Remove cable cover
USB cable
Ethernet cable
Connect D Sub 15 HD plug
Remove rubber plug
