Miyachi Unitek LMV700, Руководство оператора

Страница: 57 / 72

LMV700 Nd:YVO
4
LASER MARKER
990-545 B-1
APPENDIX B
ELECTRICAL AND DATA CONNECTIONS
Section I: External Input and Output (Ext. I/O)
Connectors
Connector for Unit:
D-Sub 25 Pins, Male
Connector for User Device: D-Sub 25 Pins, Female M2.6
Recommended Parts:
Connector
HDBB-25S (Hirose Electric Co., Ltd.)
Case HDB-CTH (Hirose Electric Co., Ltd.)
NOTE:
Be sure to use a connecting cable with a shield line and terminate the shield line appropriately.
Input Signals
Pin No. Signal Signal description
1 +24 V output Power supply for external I/O biasing.
2 Marking start
*l
When input is closed, marking will start.
3 Marking stop When input is closed, all marking will stop.
4 Laser start (Laser enable) When input is closed, all systems are enabled and activated during start-up.
5 Guide beam When input is closed, the guide beam turns
ON
.
6 Reset errors (Trouble reset) When input is closed, error (trouble) condition is reset.
7 Stop serial counter
*2
When input is closed the serial counter stops counting (either up or down).
9 External Emergency Stop When input is opened, all marking operations are stopped.
10 DI common Common Input terminal for the input signals.
19 0 V Ground for +24 V DC output.
24 Counter reset
*3
When input is closed, the serial counter is reset to either the minimum or
maximum value.
25
Remote/Local Control
Switching
When input is closed, the Laser switches to ‘Remote’ (I/O) control.
8, 20, 23 Reserved Do not use
*1 This signal is valid when the mode is set to “Remote”. Signal is invalid when mode is set to “Local”.
*2 Stops all serial counters.
*3 The signals for the individual counters can be enabled or disabled.