Mitsubishi MZ360360EX, Руководство по установке

Страница: 4 / 51

- 4 -
■
QUICK SPLICE CONNECTOR
Precautions for installing quick splice connector
- Be careful not to damage the vehicle harness when cutting the vinyl tape wound around the harness to expose
the wire to which the quick splice connector is to be installed.
- When connecting a quick splice connector, confirm that a click is heard and also visually check that its two locks
are engaged firmly.
- Before installing a quick splice connector, re-check the colors of the two wires to be connected and also the
connector terminal number from where the wire to which the connector is connected comes to prevent incorrect
connection.
- If two or more quick splice connectors are to be installed on adjacent wires, do not install them side by side
but stagger them to prevent interference between them.
- If its two locks are engaged securely, the quick splice connector will still perform properly even if its hinge breaks.
1) If the wire of the vehicle harness to which the connector is installed is covered with vinyl tube or vinyl tape, cut
it off properly and expose the wire.
2) Insert the wire of the vehicle harness firmly into the guide groove of the quick splice connector.
3) Fold the connector, then press the connector with a pair of pliers as shown until it clicks and the two locks are
engaged.
4) After confirming that the connector is connected firmly, wind vinyl tape around the connector to prevent it from
rattling.