Mitsubishi MZ360360EX, Руководство по установке

Страница: 35 / 51

- 35 -
H. ROUTING THE HARNESS TO THE
COMBINATION METER
1) Route the quick splice connector with white/black
wire and the ground terminal of the harness
③
to
the combination meter.
2) Connect the quick splice connector with white/black
wire to the black/white wire from the No. 1 terminal
of the 22-pin connector for combination meter.
3) Tighten the ground terminal of the harness ③ with
the instrument panel mounting nut as shown in the
drawing.
4) Cut the urethane sheet D
④
into several pieces
and fix the ground terminal wire to the instrument
panel with them to prevent the wire from dangling.
I. CHECKING AFTER INSTALLATION
1) Check that all the harnesses are connected correctly while referring to the wiring diagram.
2) Check that all the connectors are connected securely and the harnesses are routed properly.
3) Fix the harnesses properly to prevent them from interference and dangling using the tie-wraps ⑦ and vinyl
tape.
Check
Check
Refer to the workshop manual for the tightening
torque of the mounting nut.
Note