Mitsubishi MZ360360EX, Руководство по установке

Страница: 10 / 51

- 10 -
F. INSTALLING THE ELECTRONIC
CONTROL UNIT
1) Apply the two pieces of double-sided adhesive tape
⑥
and the urethane sheet B
④
on the electronic
control unit
①
as shown in the drawing.
2) Wipe clean and degrease the installation position
of the electronic control unit
①
at the deck
crossmember stay above the steering shaft using
isopropyl alcohol or degreaser.
3) Connect the 13-pin connector and the 12-pin
connector of the harness
③
to the electronic control
unit
①
. Then peel off the backing strips of the
double-sided adhesive tape
⑥
and attach the
electronic control unit ① to the deck crossmember
stay above the steering shaft.
4) Route the harness ③ along the instrument panel
harness and fix the harness near the electronic
control unit
①
using the tie-wrap
⑦
.
5) Bundle the excess lengths of the wires to the ground
terminal and to the quick splice connector (with
white/black wire) and fix them properly on the
instrument panel harness using the tie-wrap
⑦
.
6) Connect the antenna jack of the antenna unit ②
to the electronic control unit
①
.
7) Secure the electronic control unit ① and also the
cable of the antenna unit
②
on the deck
crossmember stay using the tie-wraps
⑦
.
8) Bundle the excess length of the antenna unit cable
and fix it to the front harness using the tie-wrap
⑦
.
- Perform this work in a well-ventilated space.
- Never use organic solvent such as thinner, benzine,
gasoline, etc.
Caution
!
Be sure not to touch the adhesive surface of the
adhesive tape by a dirty hand or glove or remove
and reapply the adhesive tape. Doing so makes
the tape lose much of its adhesion.
Caution
!
Check
Route the cable of the antenna unit
②
so that it
does not interfere with the steering shaft.
Caution
!