Mitsubishi MZ360360EX, Руководство по установке

Страница: 38 / 51

- 38 -
2) Perform the engine stop operation.
(2) Registration of the remote controller
Connect the (-) terminal of the vehicle's battery and perform the registration in the following procedure.
Beep
①
Push Stop SW for 1 seconds or more. → Buzzer sounds, and
Transmission, Stop Mark
lights approx. 3 seconds.
Go to
Troubleshooting A.
NG
Check
-The engine starter cannot function unless the remote controller is registered correctly.
- This procedure requires the keyless-entry key registered to the vehicle.
- Some steps of this procedure must be performed within the limited time. Be sure to understand this
procedure fully before starting the work.
If the required operation have not finished in a specified time, the buzzer of the ECU will beep three times.
In such case, retry the registration procedure from the beginning.
The step that has a time limit is shown by a black arrow " ".
- The remote controller will not be registered if the procedure is not performed in the correct way. In such
case, disconnect the (-) terminal of the vehicle's battery once and then retry the registration procedure
from the beginning.
Caution
!
1) Set the vehicle in the following condition.
- Open the hood.
- Close all doors (including backdoor and trunk lid). (The worker should get in the vehicle.)
- Remove the ignition key from the ignition key cylinder.
2) Insert the ignition key into the key cylinder.
Turn the key from LOCK (OFF) to ACC to LOCK (OFF).Repeat this operation 5 times within
10 seconds.
When the key is finally returned to the LOCK(OFF) position after the above operation, the
buzzer of the ECU beeps once. If the buzzer sounds once, remove the key.
NG
Go to
Troubleshooting B.
OK