Mitsubishi A953GOT-LBD-M3-H, Руководство по оборудованию

Страница: 118 / 142

A953 HANDY GOT Connection to Microcomputer 12
12-4
12.3.2 When DTR is not used
1) Connection diagram
Note: Write the "Pin number" column on the host side in accordance with the specifications
of the connected host.
2) Used connectors and connector covers
- Connector on the side of the cable dedicated to the GOT
The connector of the cable dedicated to the GOT (F9GT-HCAB-
††
M) has the following
model name. Use a counterpart connector compatible with this connector.
17JE-23250-02 (D8A2)
25-pin D-Sub, male connector manufactured by DDK Ltd. (DDK)
The cable dedicated to the GOT (F9GT-HCAB1-
††
M) is the untied wire type.
- Connector on the host side
Use a connector compatible with the used host.
3) Caution on cable preparation
Make sure that the maximum cable length does not exceed the value shown in the table
below.
Remarks
The table below shows the point of contact of the used connectors and connector covers.
GOT side (F9GT-HCAB
†
-3M)
(
†
= none or 1)
Cable connection and signal direction
Host
Signal
name
Untied
wire color
Pin
number
Pin
number
Signal
name
CD(DCD) Blue 8 FG
RD(RXD) Red 4 SD(TXD)
SD(TXD) Black 2 RD(RXD)
ER(DTR) White 3 RS(RTS)
SG(GND) Orange 10 CS(CTS)
DR(DSR) Green 5
−
RS(RTS) Yellow 6 DR(DSR)
CS(CTS) Brown 7
−
FG
(SHIELD)
Drain wire 1 ER(DTR)
Connection destination
PLC CPU
Maximum cable
length (m)
Remarks
Microcomputer
6
Total of F9GT-HCAB-3M and cable prepared by user
Total of F9GT-HCAB1-3M and cable prepared by user
When F9GT-HCAB1-10M is cut
Manufacturer Address Phone No.
DDK Ltd. (DDK)
(Daimei-Fujikura Bldg.) 2-11-20, Nishigotanda,
Shinagawa-Ward, Tokyo 141-0031, Japan
(03)3494-6611
Class D grounding