Mitsubishi MOTORS Lancer Evolution IX 2005, Дополнение к руководству по ремонту

Страница: 81 / 106

ENGINE – CAMSHAFT, VALVE STEM SEAL 11-11
2. Because camshaft bearing caps Nos. 2~5 are the same shape,
check the identification marks on them so that the bearing cap
number and the inlet and exhaust sides are not mistaken. Then
fit them in the direction shown in the diagram.
Identification marks (stamped on the front bearing cap, and on
bearing cap Nos. 2~5).
I : inlet side
E : exhaust side
3. Apply sealant at the 8 places shown in the diagram of the top
view of the cylinder head.
Semi-dry sealant: Three bond 1207D
4. Fit the rear camshaft bearing cap in the direction indicated by
the front mark.
5. In just the same way as for bearing caps Nos. 2~5, check the
identification marks on the front camshaft bearing cap so that
the exhaust side and the inlet side are not mistaken.
6. Tighten the bearing cap mounting bolts gradually, 2~3 turns at a
time, to the specified torque.
Tightening torque: 20 ± 1 N•m
7. Check that the rocker arm has been fitted correctly.
Note
Completely wipe away any sealant that has been squeezed out.
! ! G " " Fitting the camshaft oil seal
1. Apply engine oil around the entire circumference of the oil seal
lip.
2. Insert the oil seal using the special tool for installing the
camshaft oil seal (MD998713), as shown in the diagram.
Front of
engine
bearing cap No.
mark indicating
inlet side or
exhaust side
Front of engine
<Inlet side>
Front
of
engine
Front
of
engine
front mark
<Exhaust side>
front mark
camshaft oil seal
(engine oil)