Mitsubishi MOTORS Lancer Evolution IX 2005, Дополнение к руководству по ремонту

Страница: 93 / 106

ENGINE – TIMING BELT, TIMING BELT B 11-23
" " D ! ! Removing timing belt B
Caution
If planning to re-use a timing belt B, ensure that it will be
refitted the same way round, by marking the back of the belt
with chalk arrows indicating the direction of movement.
Fitting guidelines
! ! A " " Fitting timing belt B and the timing belt B tensioner
1. Check that the timing marks for the crankshaft sprocket and the
balancer shaft sprocket are aligned.
2. Fit timing belt B onto the crankshaft sprocket and the balancer
shaft sprocket. Ensure that the side of the belt under tension is
not slack.
3. As a temporary step, fit the timing belt B tensioner pulley so that
its centre is to the upper left of the centre of the mounting bolt,
and so that the flange of the pulley is facing towards the front of
the engine.
4. Adjust the tension of timing belt B.
! !
B
" "
Adjusting the tension of timing belt B
1. Hold the timing belt B tensioner between fingertips and in the
direction of the arrows, apply tension torque (3.0 ± 0.4 N·m) to
timing belt B until the side of the belt under tension becomes
taught. In this condition, tighten the mounting bolt to the
specified torque, and fit the tensioner.
Tightening torque: 19 ± 3 N·m
Caution
When tightening the mounting bolt, ensure that the
tensioner does not turn round with it. If the tensioner turns
with the mounting bolt, it could cause the tension in the belt
to become too high.
timing marks
balancer shaft
sprocket
crankshaft sprocket
side of belt
under tension
timing
marks
centre of the
pulley
centre of the
mounting bolt