Mitsubishi MOTORS Lancer Evolution IX 2005, Дополнение к руководству по ремонту

Страница: 87 / 106

ENGINE – CYLINDER HEAD GASKET 11-17
Removal guidelines
! !
A
" "
Removing the cylinder head bolts
Use the special wrench for cylinder head bolts (MB991654) to turn
the bolts 2~3 times in order to loosen them, before removing them
in the numerical order as shown in the diagram.
Fitting guidelines
! ! A " " Fitting the cylinder head gasket
1. Remove the gaskets which have been stuck onto the surface of
the gasket.
Caution
Do not allow any foreign matter to get into the channels for
coolant or oil, or into the cylinder.
2. Fit the cylinder head gasket to the cylinder head, so that the
holes in the cylinder head gasket match up with the holes in the
cylinder head.
! ! B " " Fitting the cylinder head bolts
1. Check that the length of the body of cylinder head bolts is less
than the maximum permitted. If the length is in excess of the
maximum permitted, replace the bolt with a brand new one.
Maximum length (A): 99.4mm
2. Apply a small amount of engine oil to the screw thread of the
bolt, and to the washer.
Front of engine
(engine oil)