Mitsubishi MOTORS Lancer Evolution IX 2005, Дополнение к руководству по ремонту

Страница: 35 / 106

INTAKE & EXHAUST –
EXHAUST MANIFOLD
15-9
Removal procedure
1. Exhaust manifold heat protector
2. Air pipe ASSY connection
3. O2 sensor
4. Turbocharger heat protector
5. Turbocharger water feed pipe connection
6. Gasket
7. Water hose connection
8. Oil feed pipe
9. Gasket
10. Starter
11. Oil return pipe
12. Oil return pipe gasket (turbocharger side)
13. Oil return pipe gasket (oil pan side) 14. Vacuum hose connection
15. Air outlet fitting
16. Air outlet fitting gasket
17. Exhaust fitting bracket
18. Turbocharger and exhaust fitting ASSY
19. Turbocharger ASSY
20. Exhaust fitting gasket
21. Exhaust fitting
22. Turbocharger gasket
23. Turbocharger water return pipe
24. Gasket
25. Exhaust manifold
26. Exhaust manifold gasket
Removal guidelines
" "
A
! !
Removing the O2 sensor
After removing the O2 sensor connector and the clamp, use the
special O2 sensor wrench (MD998770) to remove the O2 sensor.
" " B ! ! Removing the oil feed pipe
Caution
After removing the oil feed pipe, ensure that there is no foreign
matter in the oil access hole on the turbocharger.
Fitting guidelines
! !
A
" "
Fitting the turbocharger ASSY
1. Clean away any grease clogging the connection between the oil
pipe and the water pipe, and any grease clogging the eyebolts
and the inside of the pipes.
2. If there is any carbon in the oil access on the turbocharger
ASSY, clean it or blow it away.
Caution
Ensure that no foreign matter gets inside the turbocharger
ASSY.
" " A ! !
" "
B
! !
! !
D
" "
! ! C " "
! !
B
" "
! !
A
" "
O2 sensor